Noncontact Dot Measurement by Red Laser Alignment

Have you ever fallen into difficult that you are always not able to find a clearly visible dot on certain surface? Sometimes you cannot make a quick and efficient dot projection in very long distance. There are also many similar conditions that you are not able to make an accurate dot, thus it is quite necessary to look for new solution of 650nm red dot laser alignment to make rapid and bright red dot on targeted surfaces. This kind of laser light supporting alignment laser is efficient enough to make high accuracy and high brightness dot projection with noncontact red light on required places.
This new laser diode technology applied alignment laser adopts 650nm red laser diode as light emitting source, providing a type of noncontact red light on targeted surfaces. It can be widely used in garment laser positioning, button positioning, laser marking machine, wheel forming machine or rubber processing etc. No matter at what kind of dot measurement occasions, this alignment laser is always efficient enough to make convenient, rapid, direct and practical dot projection on all kinds of positioning surfaces successfully. It cannot only greatly improve working efficient, but play very important part in modern laser positioning and calibration. As one of the most important accessory of line measuring tool, this 650nm red dot laser alignment has just made alignment easily and precisely. It is just the most wonderful substitute of ruler, triangular board, square meter, or blocking board etc.
Sometimes users are requiring continuous dot projection, it will need this 650nm red laser alignment being designed with outside designed DC input power supply. Not the same as battery operating mode, it has no need of battery change during the whole process of dot projection work. In addition, users should also know the required operating voltage in order to provide powerful enough electric power. Once users have got an alignment laser with an output power of less than 30mW, it is no need to choose high voltage. The suitable operating voltage for low powered red laser alignment should be among 3V to 3.6V. On condition that users are selecting high powered alignment laser with output power range from 50mW to 100mW, it is necessary to choose higher voltage of 4V to 5V so as to provide powerful enough operating voltage in operation.
The time users are pointing alignment laser on targeted surfaces, it should be mounted on equipment or devices with mounting bracket. Sometimes mechanical power cannot support users to make dot projection, while red dot laser alignment is efficient enough to make dot projection on required surfaces. It can be equipped vertically or horizontally on required surfaces until getting the most satisfied dot projection.